Cisco Firepower 1120 하드웨어 설치 매뉴얼 - 페이지 24

{카테고리_이름} Cisco Firepower 1120에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 1120 42 페이지. Connected grid router
Cisco Firepower 1120에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (30 페이지), 설치 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (10 페이지), 매뉴얼 (6 페이지), 하드웨어 설치 매뉴얼 (42 페이지), 배포 매뉴얼 (8 페이지), 시작하기 (42 페이지)

Installation Warnings

Warning

Statement 1005—Circuit Breaker

This product relies on the building's installation for short-circuit (overcurrent) protection. To reduce

risk of electric shock or fire, ensure that the protective device is rated not greater than: 20 A, 120 V, and

16 A, 250 V

Warning

Statement 1015—Battery Handling

To reduce risk of fire, explosion or leakage of flammable liquid or gas:

• Replace the battery only with the same or equivalent type recommended by the manufacturer.

• Do not dismantle, crush, puncture, use a sharp tool to remove, short external contacts, or dispose

• Do not use if battery is warped or swollen.

• Do not store or use battery in a temperature > 60° C.

Warning

Statement 1017 Restricted Area

This unit is intended for installation in restricted access areas. Only skilled, instructed, or qualified

personnel can access a restricted access area.

Warning

Statement 1021 SELV Circuit

To avoid electric shock, do not connect SELV circuits to telephone-network voltage (TNV) circuits.

LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports

both use RJ-45 connectors. Use caution when connecting cables.

Warning

Statement 1024 Ground Conductor

This equipment must be grounded. To reduce the risk of electric shock, never defeat the ground conductor

or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate

electrical inspection authority or an electrician if you are uncertain that suitable grounding is available.

Warning

Statement 1029 Blank Faceplates and Cover Panels

Blank faceplates and cover panels serve three important functions: they reduce the risk of electric shock

and fire, they contain electromagnetic interference (EMI) that might disrupt other equipment, and they

direct the flow of cooling air through the chassis. Do not operate the system unless all cards, faceplates,

front covers, and rear covers are in place.

Cisco Firepower 1100 Series Hardware Installation Guide

of the battery in fire.

Installation Preparation