Cisco Firepower 1120 하드웨어 설치 매뉴얼 - 페이지 30

{카테고리_이름} Cisco Firepower 1120에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 1120 42 페이지. Connected grid router
Cisco Firepower 1120에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (30 페이지), 설치 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (10 페이지), 매뉴얼 (6 페이지), 하드웨어 설치 매뉴얼 (42 페이지), 배포 매뉴얼 (8 페이지), 시작하기 (42 페이지)

Rack-Mount the Chassis

The rack is a standard Electronic Industries Association (EIA) rack. It is a 4-post-EIA-310-D, which is the

current revision as specified by EIA. The vertical hole spacing alternates at .50 inches (12.70 mm) to .625

inches (15.90 mm) to .625 inches (15.90 mm) and repeats. The start and stop space is in the middle of the

.50-inch holes. The horizontal spacing is 18.312 inches (465.1 mm), and the rack opening is specified as a

minimum of 17.75 inches (450 mm).

Step 1

Attach both brackets (part number 700-117078-01) to the sides of the chassis using the four M4 x 8-mm Phillips screws

(part number 848-0451-01) that shipped with your chassis. After the brackets are secured to the chassis, you can mount

it in the rack.

Figure 23: Attach Brackets to Chassis

Chassis back panel

M4 x 8-mm Phillips screws (two per side)

Step 2

Attach the chassis to the rack using the screws that shipped with the chassis.

Note

There are three sets of four screws that you can use to secure the chassis to your rack. Chose the screws that

fit your rack. See

We recommend that you install the chassis with the I/O side (rear panel) facing the cold aisle. See the following illustration

for an example of air flow from rear panel (cold aisle) to the front panel (hot aisle).

Cisco Firepower 1100 Series Hardware Installation Guide

Package Contents, on page 5

Rack-mount bracket

—

for the list of rack screws.

Rack-Mount the Chassis