Cisco Firepower Management Center 2000 시작하기 매뉴얼 - 페이지 30
{카테고리_이름} Cisco Firepower Management Center 2000에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower Management Center 2000 42 페이지. Firepower management center
페이지 인쇄
3.
3 Select Patches/Rule Updates
page
31.
4.
4 Download and Mount ISO
5.
5 Run the Install
Identifying the Appliance's Management Interface
The first step in running the restore utility is to identify the management interface on the appliance you want to
restore, so that the appliance can communicate with the server where you copied the ISO and any update files. If
you are using LOM, remember that the management IP address for the appliance is not the LOM IP address.
To identify the appliance's management interface:
1.
From the restore utility main menu, select
2.
Select the appliance's management interface (generally
3.
Select the protocol you are using for your management network:
Options for assigning an IP address to the management interface appear.
4.
Select a method to assign an IP address to the management interface:
—
If you select
length, and default gateway for the management interface.
—
If you select
default gateway for the management interface, then displays the IP address.
5.
When prompted, confirm your settings.
If prompted, confirm the IP address assigned to the appliance's management interface.
What to Do Next
Continue with the next section,
Specifying ISO Image Location and Transport Method
After you configure the management IP address that the restore process will use to download files it needs, you
must identify which ISO image you will use to restore the appliance. This is the ISO image that you downloaded
from the Support Site (see
server, or SCP-enabled host.
The interactive menu prompts you to enter any necessary information to complete the download, as listed in the
following table.
Cisco Firepower Management Center Getting Started Guide
(optional) —
— see
Downloading the ISO and Update Files and Mounting the Image, page
— see
Invoking the Restore Process, page
, a series of pages prompts you to manually enter the IP address, network mask or prefix
Static
, the appliance automatically detects the IP address, network mask or prefix length, and
DHCP
Specifying ISO Image Location and Transport
Obtaining the Restore ISO and Update Files, page
Restoring a Firepower Management Center to Factory Defaults
Updating System Software and Intrusion Rules During Restore,
32.
1 IP Configuration
.
).
eth0
IPv4
or
IPv6
.
Static
or
DHCP
:
Method.
25), and stored on a web server, FTP
32.
30