Cisco Firepower Management Center 3500 시작하기 매뉴얼 - 페이지 4
{카테고리_이름} Cisco Firepower Management Center 3500에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower Management Center 3500 42 페이지. Firepower management center
페이지 인쇄
—
If your FMC is running Firepower Version 6.5+, this gives you access to the FMC CLI. To access the Linux
shell, continue with Step 2.
2.
To access the Linux shell form the FMC CLI, enter the expert command.
Installation and Initial Setup for Versions 6.5+
Note:
Firepower Versions 6.5+ are not supported on FMC models 750, 1500, and 3500.
The first time you log into the FMC running Versions 6.5+, an Initial Configuration Wizard guides you through
configuring the new appliance to communicate on your trusted management network. The wizard presents a
streamlined initial configuration process and automatically establishes some weekly maintenance activities to
keep your system up-to-date and your data backed up.
The FMC management interface is pre-configured to accept an IPv4 address assigned by the Dynamic Host
Configuration Protocol (DHCP). If the FMC fails to obtain a DHCP lease, the management interface uses a fallback
IPv4 address of 192.168.45.45.
Note:
If you are connecting to an FMC for the first time after performing a System Restore and you chose to retain
license and network settings, the management interface IP address is the same as it was before you performed
the System Restore. Proceed directly to
To install and set up an FMC running Versions 6.5+:
1.
Install the appliance as described in
2.
To perform the initial setup you have one of two choices:
—
If your network does not use DHCP and your PC cannot reach the fallback address (or the address retained
in a System Restore), we recommend you perform the initial setup by connecting a computer directly to
the FMC's physical management interface as described in
Using the Management Interface, page
—
If your local DHCP will assign an address to the FMC, use a keyboard and monitor to set up the appliance;
see
Access the Firepower Management Center Using a Keyboard and Monitor, page
Install the Appliance
These instructions are an abbreviated version of the steps to physically install the appliance. For detailed
instructions, see the Cisco Firepower Management Center 750, 1500, 2000, 3500, and 4000 Hardware Installation
Guide.
Procedure
1.
Mount the appliance in your rack using the mounting kit and its supplied instructions.
2.
Attach power cords to both power supplies and plug them into separate power sources.
If you do not connect both power supplies, an amber warning indicator lights on the chassis front panel and
the FMC web interface displays a health alert.
3.
Turn on the appliance by pressing the power switch located on the front panel.
After you press the power switch the appliance may turn on briefly and then appear to shut down with the
exception of the amber power indicator light on the chassis front panel. This is normal; pressing the power
button again causes the appliance to power up with the power indicator light green.
Cisco Firepower Management Center Getting Started Guide
Firepower Management Center Initial Configuration Wizard, page
Install the Appliance, page
5.
Installation and Initial Setup for Versions 6.5+
4.
Access the Firepower Management Center
7.
6.
4