Cisco Firepower Management Centers 사용 설명서 - 페이지 4
{카테고리_이름} Cisco Firepower Management Centers에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower Management Centers 20 페이지. Memory upgrade
페이지 인쇄
Removing the Chassis Cover
Step 1
Observe the ESD precautions described in
precautions described in
Step 2
Remove the security screws from the front of the chassis:
•
For Rev. 1, there are two (2) screws (see "1" in
•
For Rev. 2, there are three (3) screws (see "1" in
Step 3
Remove the security screw from the rear of the chassis. See "2" in
Step 4
Slide the cover towards the rear by pushing on the blue grip points on the chassis cover:
•
For Rev. 1, there is one (1) grip point (see "3" in
•
For Rev. 2, there are two (2) grip points (see "3" in
Step 5
Lift the over off and set aside.
What to Do Next:
•
Remove the processor air duct as described in the
Firepower Management Center 750" section on page
Figure A-1
1
Front security screws
2
Rear security screw
Cisco Firepower Management Center 750, 1500, 2000, 3500, and 4000 Hardware Installation Guide
A-4
Appendix A
Working in an ESD Environment, page A-2
Safety Warnings, page
Removing the Cover from a MC750 Rev. 1
Memory Upgrade Instructions for Firepower Management Centers
A-2.
Figure
A-1).
Figure
A-2).
Figure A-1
Figure
A-1).
Figure
A-2).
"Removing the Processor Air Duct from
A-6.
3
Rubber grip point
4
Top cover
and the safety
and
Figure
A-2.