Cisco MC2000 사용 설명서 - 페이지 8

{카테고리_이름} Cisco MC2000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco MC2000 20 페이지. Firepower management center
Cisco MC2000에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (42 페이지)

페이지 인쇄

Removing the Processor Air Duct

Removing the Processor Air Duct from Firepower Management Center

1500 and 3500

The Firepower MC1500 and MC3500 share some of the same form factors. The following procedure can

apply to either device.

Note

Before the processor air duct can be removed from a MC1500 and MC3500, the adjacent PCI Riser

Assembly must first be removed.

To remove the processor air duct from a Firepower MC1500 or MC3500:

Step 1

Observe the ESD precautions described in

precautions described in

Step 2

Disconnect any cables attached to any add-in cards.

Step 3

Grasp both riser latches with thumb and forefinger and pull up to release the riser assembly.

Step 4

Lift riser assembly straight up (see "1" in

Figure A-6

Step 5

Set the riser assembly upside down to avoid damage to the riser card connector.

Step 6

Lift the processor air duct from its location over the two processor sockets (see "1" in

Cisco Firepower Management Center 750, 1500, 2000, 3500, and 4000 Hardware Installation Guide

A-8

Safety Warnings, page

Removing the PCI Riser Assembly from a MC1500 or MC3500

PCI riser assembly

Appendix A

Memory Upgrade Instructions for Firepower Management Centers

Working in an ESD Environment, page A-2

A-2.

Figure

A-6).

— —

and the safety

Figure

A-7).