Cisco MC4000 사용 설명서 - 페이지 5
{카테고리_이름} Cisco MC4000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco MC4000 20 페이지. Firepower management center
Cisco MC4000에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (42 페이지)
페이지 인쇄
Appendix A
Memory Upgrade Instructions for Firepower Management Centers
Figure A-2
1
2
Removing the Cover from Firepower Management Center 1500 and 3500
The MC1500 and MC3500 Management Centers share some of the same form factors. The following
procedure can apply to either device.
To remove the cover from a Firepower MC1500 or MC3500:
Note
A nonskid surface or a stop behind the MC1500 or MC3500 may be needed to prevent the device from
sliding on your work surface.
Step 1
Observe the ESD precautions described in
precautions described in <Blue>Safety Warnings on page 2.
Step 2
Remove the security screw if it is installed (see "1" in
Step 3
Cut the warranty label on the unit if it is intact.
Step 4
While holding in the blue button on the top of the chassis (see "3" in
back until it stops (see "4" in
•
•
Step 5
Insert your finger in the notch (see "2" in
What to Do Next:
•
Removing the Cover from a MC750 Rev. 2
1
Front security screws
Rear security screw
Figure
On the MC1500, the button is on the left.
On the MC3500, the button is on the right as shown in
Remove the processor air duct as described in the
Firepower Management Center 1500 and 3500" section on page
Cisco Firepower Management Center 750, 1500, 2000, 3500, and 4000 Hardware Installation Guide
4
3
3
Rubber grip points
4
Top cover
Working in an ESD Environment, page A-2
Figure
A-3).
Figure
Figure
A-3) and lift the cover upward to remove it.
"Removing the Processor Air Duct from
Removing the Chassis Cover
2
3
and the safety
A-3).
Figure
A-3), slide the top cover
A-3.
A-8.
A-5