Cisco MCS-78 Series 오류 코드 목록 - 페이지 9
{카테고리_이름} Cisco MCS-78 Series에 대한 오류 코드 목록을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco MCS-78 Series 13 페이지. Media convergence server
페이지 인쇄Cisco - Cisco MCS-78XX Boot Error Codes
1618 - PCI slots powered down.
Check PCI hot plug
enabler connectors.
1620 - Locked SCSI Bus
Detected. Verify SCSI bus
cabling. System halted.
1621 - Current SCSI Jumper
Board Not Installed.
1622 - Internal SCSI Jumper
Board Not Installed.
1703 - SCSI cable error
detected. Internal SCSI
cable not attached
to system board
connector. System halted.
1720 - Slot x Drive
Array - SMART Drive
Detects Imminent
Failure SCSI:
Port y: SCSI ID x
http://kbase.cisco.com/paws/servlet/ViewFile/12138/mcs_boot.xml?convertPaths=1
failure.
PCI hot plug
enabler is
None
missing or
failed.
SCSI bus
None
failure.
Improper
None
SCSI bus
cabling.
The system
has detected
that the array
None
enabler board
is not
installed.
Incorrect
None
cabling.
Indicated
drive has
reported a
SMART
predictive-
None
failure
condition and
can fail at
some time in
the future.
controller
assembly.
Check and
replace missing
or failed
controller
assembly.
1. Run
diagnostics.
2. Replace
failed assembly
as indicated.
Check
documentation
for proper
SCSI bus
cabling.
Install the array
enabler board.
Ensure that the
integrated
SCSI controller
has SCSI
termination
attached.
1. If the drive
is part of a
nonfault-
tolerant
configuration,
back up all data
before you
replace the
drive and
restore all data
afterward. If
the drive is part
of a fault-
tolerant
configuration
do not replace
the drive unless
Page 9 of 13
10/2/2008