B2 Anno 소유자 매뉴얼 - 페이지 5

{카테고리_이름} B2 Anno에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. B2 Anno 10 페이지. High performance amplifiers

For safety purposes, install the amplifier in a dry and well ventilated location and

make sure no cables or other harness of the car is interfaced with the mounting location or

will present a hazard to the cars' cable, control cables, fuel lines/tanks, hydraulic lines or other

components of the vechicle.

4-3. +12V, GND, REM CONNECTION

12V ( POWER CONNECTION )

Before mounting

amplifiers, disconnect the negative ( ) wire from the battery to protect

any accidentIal damage to the amplifier or the audio system.

series are designed to use 0 AWG power and Ground connection.

Connect the power cables to power terminal labeled as + 12V

Ref 0.5 & Anno

are not equipped with Fuses. So you should use extral fuses.

connect one end of the fuse holder to the power cable and the other end of the fuse holder to

positive battery within 20 cm of the same cable.

This fuse location will protect the system and the vehicle against the possibility of a short circuit

in the power cable. Be sure to use fuses and a fuse holder adequate for the application

GND ( GROUND CONNECTION )

Locate a secure grounding connection as close to the amplifier as possible.

Make sure the location is clean and provides a direct electrical connection to the frame

of the vehicle. Connect one end of a short piece of the same size cable as the power cable

to the grounding point. Run one end of the cable to the grounding point.

Run the other end of the cable to the mounting location.

Connect the ground cable to the screw terminal labeled as GND.

REM ( REMOTE CONNECTION )

Run a remote turn on cable from the switched + 12V source.

This may be a toggle switch, a relay, or your source unit's remote trigger cables, or power antenna

trigger cable.

Connect the remote turn on cable to the power terminal labeled as REM.

+12V, GND, REM CONNECTION DIAGRAM

Headunit

Remote turn on

Ground

FUSE

250A

12V

Main Battery