Cisco Nexus 7000 Series 구성 매뉴얼 - 페이지 20

{카테고리_이름} Cisco Nexus 7000 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Nexus 7000 Series 28 페이지. Switch chassis
Cisco Nexus 7000 Series에 대해서도 마찬가지입니다: 참조 매뉴얼 (2 페이지), 설치 지침 매뉴얼 (39 페이지), 참조 (34 페이지), 설치 매뉴얼 (18 페이지), 구성 (8 페이지), 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (29 페이지), 교체 지침 매뉴얼 (14 페이지), 교체 지침 매뉴얼 (21 페이지), 설치 매뉴얼 (16 페이지), 문제 해결 매뉴얼 (10 페이지)

Enabling a Catena Instance

• egress-port-group epg-name—Specifies the egress port group.

• egress-device-group edg-name—Specifies the egress device group.

• mode mode—Specifies the mode types—drop, bypass, or forward—for the received packets.

Currently, you must configure separate instances for Layer 2 and Layer 3 modes. A catena instance can

comprise multiple chains that are independent of each other. The traffic in each chain is forwarded as defined.

However, if there is an overlap between packets from different chains at the ingress port, then all the chains

configured on that ingress interface will be evaluated. If a match is found on the ingress interface, then the

matching chain is accepted and forwarded.

Enabling a Catena Instance

Before You Begin

1 Enable the Catena solution. For details about how to enable this, see

Solution."

2 Configure the Catena instance. For details about how to enable this, see

3 In the routed mode deployment, you must run the following commands before enabling the Catena instance:

Procedure

Step 1

Enter global configuration mode:

switch# configure terminal

Step 2

Create a Catena instance and enter Catena instance configuration mode:

switch(config)# catena instance-name

Step 3

Enable the Catena instance:

switch(config-catena-instance)# no shutdown

To verify the Catena configuration, use one of the following commands:

Cisco Nexus 7000 Series Switches Configuration Guide: The Catena Solution

• feature pbr

• feature sla sender

• feature sla responder

Configuring the Catena Solution

"Enabling or Disabling the Catena

"Configuring a Catena

Instance."