Cisco ONS 15454 포장 풀기 및 설치

{카테고리_이름} Cisco ONS 15454에 대한 포장 풀기 및 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ONS 15454 40 페이지. Four-shelf and zero-shelf bay assembly
Cisco ONS 15454에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (22 페이지), 설치 (32 페이지), 설치 (32 페이지), 포장 풀기 및 설치 (42 페이지)

페이지 인쇄

Unpacking and Installing the Cisco ONS 15454

Four-Shelf and Zero-Shelf Bay Assembly

Cisco ONS 15454 Four-Shelf and Zero-Shelf Bay Assembly

Overview

The Cisco ONS 15454 four-shelf and zero-shelf bay assemblies provide a dual-feed, pre-wired TPA-type

fuse and alarm panel, two vertical fiber ducts, and two 2.38-inch vertical extenders and extender bases.

The four-shelf bay assembly also provides a pre-installed, four-shelf configuration that includes four

ONS 15454 shelf assemblies with electrical interface assembly (EIA) panels or EIA blank cover panels.

This guide describes how to unpack and install the Cisco ONS 15454 four-shelf and zero-shelf bay

assembly. Because it is a complete system, installation simply requires you to remove the unit from the

shipping pallet, move the unit into place, secure it, and supply power and ground attachment. Refer to

the Cisco ONS 15454 user documentation for component-specific installation and replacement

procedures.

This guide includes the following sections:

•

Corporate Headquarters:

Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

Figure 1 on page 2

Safety Recommendations

Included Material

Recommended Material

Unpacking Instructions

Installation Instructions

–

Slab Floor Plan

Raised Floor Plan

–

Install the ONS 15454 Four-Shelf or Zero-Shelf Bay Assembly

Route Fiber Through the Base

–

Cabling Illustrations

Fuse and Alarm Panel Wiring

–

FAP Alarming

FAP Output and Input Power

–

shows a four-shelf bay assembly.