Cisco ONS 15454 SDH 절차 매뉴얼 - 페이지 11
{카테고리_이름} Cisco ONS 15454 SDH에 대한 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ONS 15454 SDH 22 페이지. Install cards and fiber-optic cable

Chapter 2 Install Cards and Fiber-Optic Cable
Verify that the card is inserted correctly and close the latches/ejectors on the card.
Step 4
Note
Verify the LED activity:
Step 5
•
•
•
•
•
Continue with the
Step 6
necessary.
Stop. You have completed this procedure.
NTP-D18 Install Ethernet Cards and Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Class I (21 CFR 1040.10 and 1040.11) and Class 1M (IEC 60825-1 2001-01) laser products. Statement 291
Warning
78-18118-01
It is possible to close the latches/ejectors when the card is not completely plugged into the
backplane. Ensure that you cannot insert the card any further.
The red FAIL LED turns on for 10 to 15 seconds.
If the red FAIL LED does not turn on, check the power.
The red FAIL LED blinks for 30 to 40 seconds.
All LEDs blink once and turn off for 1 to 5 seconds.
The ACT or ACT/STBY LED turns on. The SF LED can persist until all card ports connect to their
far end counterparts and a signal is present.
If you insert a card into a slot provisioned for a different card, all LEDs turn off.
Note
If the red FAIL LED is on continuously or the LEDs behave erratically, the card is not
Note
installed properly. Remove the card and repeat Steps
"NTP-D18 Install Ethernet Cards and Connectors" procedure on page 2-11
This procedure installs the Ethernet cards (E100T-G, E1000-2-G, G1K4,
ML100T-12, ML1000-2, ML100X-8, ML-MR-10, CE-100T-8, CE-1000-4,
and CE-MR-10).
Ethernet cards
NTP-D15 Install the Common Control Cards, page 2-2
As needed
Onsite
None
NTP- D18 Install Ethernet Cards and Connectors
2
to 5.
Cisco ONS 15454 SDH Procedure Guide, R8.5
if
2-11