Cisco ONS 15600 카드 설정 변경
{카테고리_이름} Cisco ONS 15600에 대한 카드 설정 변경을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ONS 15600 14 페이지. Install the bay and backplane connections
Cisco ONS 15600에 대해서도 마찬가지입니다: 참조 매뉴얼 (29 페이지), 매뉴얼 (10 페이지), 참조 매뉴얼 (22 페이지), 설치 지침 매뉴얼 (14 페이지)
페이지 인쇄
Change Card Settings
This chapter explains how to change transmission settings on cards in a Cisco ONS 15600.
Before You Begin
As necessary, complete the
Before performing the following procedures, investigate all alarms and clear any trouble conditions.
Refer to the Cisco ONS 15600 Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
February 2008
"NTP-E57 Document Existing Provisioning" procedure on page
NTP-E157 Provision a Multirate PPM, page
pluggable port module (PPM), for the ASAP card. If a multirate PPM was preprovisioned, this
procedure is unnecessary.
NTP-E151 Provision an Optical Line Rate, page
optical line rate on a multirate PPM for the ASAP card. Single-rate PPMs do not need to be
provisioned.
NTP-E150 Change the Optical Line Rate, page
optical line rates for multirate PPMs on the ASAP card.
NTP-E149 Delete Pluggable Port Modules, page
delete PPMs for the ASAP card.
NTP-E66 Modify Line and Status Thresholds for Optical Ports, page
this procedure to change line (drop) and threshold settings for all OC-N cards.
NTP-E105 Change an Optical Port to SDH, page
change an optical port from SONET to SDH.
NTP-E125 Change Card Service State, page
card service state.
C H A P T E R
11-2—Complete this procedure to provision a multirate
11-3—Complete this procedure to provision the
11-4—As needed, complete this procedure to edit
11-5—As needed, complete this procedure to
11-6—As needed, complete
11-12—As needed, complete this procedure to
11-13—As needed, complete this procedure to change
Cisco ONS 15600 Procedure Guide, R5.0
11
7-2.
11-1