Cisco S195 시작하기 매뉴얼 - 페이지 6

{카테고리_이름} Cisco S195에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco S195 18 페이지. Web security appliance
Cisco S195에 대해서도 마찬가지입니다: 매뉴얼 (24 페이지), 하드웨어 설치 매뉴얼 (50 페이지)

페이지 인쇄

Temporarily Change Your IP Address for Remote Access

To remotely configure the appliance using the network connection, you must temporarily change the

IP address of your computer.

Make a note of your current IP configuration settings as you will need to revert to these settings after

Note

you finish the configuration.

Alternatively, you can use the serial console to configure the appliance, without changing the IP address.

If you use the serial console, see

Temporarily Change Your IP Address on Windows

Note

The exact steps depend on the version of your operating system.

Procedure

Connect your laptop to the primary Management Port (labeled M1) using the cross over or Ethernet cable

Step 1

included in the system box. The Cisco Web Security Appliance uses the M1 Management port only. See

"Plan the Installation" section on page

Go to the Start menu and choose Control Panel.

Step 2

Double-click Network and Sharing Center.

Step 3

Cisco Web Security Appliance S195, S395, S695, and S695F Getting Started Guide

Connect to the Appliance, page