Cisco SCE8000 GBE 빠른 시작 매뉴얼 - 페이지 13

{카테고리_이름} Cisco SCE8000 GBE에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SCE8000 GBE 25 페이지. 10gbe platform
Cisco SCE8000 GBE에 대해서도 마찬가지입니다: 구성 매뉴얼 (18 페이지), 제거 및 교체 절차 (36 페이지), 설치 (21 페이지)

페이지 인쇄

Table 2 lists commands for displaying the currently configured values and for configuring these parameters. It also lists the

command mode for each configuration command. All show commands are executed from the User Exec command mode.

Table 2

Initial Setup Configuration

Parameter

Management IP address

and subnet mask

Default gateway

Hostname

Authorization level

passwords

Clock

Time zone

Domain name server

RDR formatter

destination

Connecting the Management Interface

The SCE8000-SCM-E is equipped with one active management port. This is a GBE port with a RJ-45 interface. It is located in

slot# 1 of the Cisco SCE8000 chassis, and labeled Port1.

This port provides access from a remote management console to the Cisco SCE8000 through a LAN.

Cabling the Management Port

Plug the Ethernet cable provided (with attached RJ-45 connector) into Port 1on the front panel of the SCE8000-SCM-E

Step 1

(item #3 in

Figure

show Command

show interface GigabitEthernet 1/1

ip address

show ip default-gateway

show hostname

N/A

show clock

show calendar

show timezone

show hosts

show rdr-formatter destination

9.)

Configuration Command

ip address x.x.x.x subnet-mask

ip default-gateway x.x.x.x

hostname host-name

enable password level level

[encryption-type] password

calendar set hh:mm:ss day month

year

clock read-calendar

clock set hh:mm:ss day month year

clock update-calendar

clock timezone zone-name

offset-hours

ip domain-lookup

ip domain-name domain-name

ip name-server server-address1

[server-address2] [server-address3]

rdr-formatter destination ip-address

port port-number

Configuration Command

Mode

GigabitEthernet

Interface configuration

Global configuration

Privileged EXEC

Global configuration