B2 Audio RAGE1200.6 사용자 설명서 - 페이지 7

{카테고리_이름} B2 Audio RAGE1200.6에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. B2 Audio RAGE1200.6 13 페이지.

speaker connection

rage 2500

We recommend using minumum10 Ga speaker cables to acquire the intended performance & e ciency.

Run the speaker cables from your speakers to the ampli er's mounting location.

Ensure these are ran separately and away from high current cables and if possible the RCA cables as well.

In all cases where cables are penetrating the vechile's chassis use grommets to protect the cable.

Connect the speaker wires according to the terminals on the speaker(s). Strip 3/8'' / 1 cm of insulation of the end of

each cable and twist the cable strands together tightly. Make sure there are no stray strands that could touch other

cables or terminals as it can cause a short circut.

Crimp spade plugs over the end of the cable or tin the ends with solder to provide a solid terminal.

Connect the cable ends to the ampli er as shown in the diagram. Note, the ampli er's speaker terminals are

internally bridged.

Installation of the amplifier shall be done in the following steps:

1. Connect the +12V wire, keep in mind this wire has to be fused at the battery as well. 2. Ensure the ground is

appropriate, then connect it to the ampli er. 3. Connect the switched remote. 4. Reattach negative wire (ground)

to the battery. 5. Operation over 17.5V will cause the ampli er to go into protect & can void the warranty!

GND

+12 V

REM

CAUTION

SPEAKER

250 A fuse rating

Speaker impedance 1 Ohm ~ 8 Ohm

will reach thermal at a faster rate & will eventually go into protect.

Impedance load under 1 ohm is not warranted!