Cisco SNS-3495 series 설치 매뉴얼 - 페이지 15

{카테고리_이름} Cisco SNS-3495 series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SNS-3495 series 19 페이지. Sns-3400 series
Cisco SNS-3495 series에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지), 문제 해결 매뉴얼 (8 페이지)

페이지 인쇄

1. System Bios and CIMC Firmware

Chapter 8

Installing the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances

Figure 8-5

Using the BIOS Recovery Header J41

Depending on which stage the BIOS becomes corrupted, you might see different behavior.

•

Service Header Locations

FAN1

FAN2

FAN3

FAN4

FAN5

J41 BIOS RCVR BOOT

If the BIOS BootBlock is corrupted, you might see the system get stuck on the following message:

Initializing and configuring memory/hardware

If it is a non-BootBlock corruption, the following message is displayed:

****BIOS FLASH IMAGE CORRUPTED****

Flash a valid BIOS capsule file using CIMC WebGUI or CLI interface.

IF CIMC INTERFACE IS NOT AVAILABLE, FOLLOW THE STEPS MENTIONED BELOW.

1. Connect the USB stick with recovery.cap file in root folder.

2. Reset the host.

IF THESE STEPS DO NOT RECOVER THE BIOS

1. Power off the system.

2. Mount recovery jumper.

3. Connect the USB stick with recovery.cap file in root folder.

4. Power on the system.

Wait for a few seconds if already plugged in the USB stick.

REFER TO SYSTEM MANUAL FOR ANY ISSUES.

Connecting and Powering On the Cisco SNS-3415/3495 Appliance

CPU1

CPU2

J37 Clear CMOS

Installation and Upgrade Guide for Cisco Secure Access Control System 5.6

PCIe1

PCIe2

PSU2

PSU1

8-15