Cisco SNS-3515-K9 소프트웨어 설치 - 페이지 6
{카테고리_이름} Cisco SNS-3515-K9에 대한 소프트웨어 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SNS-3515-K9 38 페이지.
Cisco SNS-3515-K9에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지)
페이지 인쇄
Cisco SNS 3515 or SNS 3595 Appliance Back Panel View
8
The following table describes the LEDs located on the back panel of the Cisco SNS 3515 or Cisco SNS 3595
appliance.
LED Name
Optional mLOM 1-GbE SFP+ (there is a single status
LED)
Optional mLOM 1-GbE BASE-T link speed
Optional mLOM 1-GbE BASE-T link status
1-GbE Ethernet dedicated management link speed
1-GbE Ethernet dedicated management link status
1-GbE Ethernet link speed
1-GbE Ethernet link status
Rear unit identification
Install Cisco ISE Software on Cisco SNS Appliances
6
USB 3.0 ports (two)
Install Cisco ISE Software on Cisco SNS Appliances
State
• Off—No link is present.
• Green, steady—Link is active.
• Green, blinking—Traffic is present on the active
link.
• Off—Link speed is 10 Mbps.
• Amber—Link speed is 100 Mbps/1 Gbps.
• Green—Link speed is 10 Gbps.
• Off—No link is present.
• Green—Link is active.
• Green, blinking—Traffic is present on the active
link.
• Off—Link speed is 10 Mbps.
• Amber—Link speed is 100 Mbps.
• Green—Link speed is 1 Gbps.
• Off—No link is present.
• Green—Link is active.
• Green, blinking—Traffic is present on the active
link.
• Off—Link speed is 10 Mbps.
• Amber—Link speed is 100 Mbps.
• Green—Link speed is 1 Gbps.
• Off—No link is present.
• Green—Link is active.
• Green, blinking—Traffic is present on the active
link.
• Off—The unit identification LED is not in use.
• Blue—The unit identification LED is activated.