finder Bliss 2 사용자 설명서 - 페이지 3
{카테고리_이름} finder Bliss 2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. finder Bliss 2 10 페이지. Smart chronothermostat
페이지 인쇄
OVERVIEW OF SCREENS & ICONS
ROOM TEMPERATURE
Thermostat is set to AUTOMATIC mode
(AUTO) and will respond to programming
via the App.
Current room temperature is displayed
TARGET TEMPERATURE IN MANUAL MODE
The thermostat is set to MANUAL mode.
The target temperature is displayed
MANUAL MODE
Thermostat is set to Manual mode.
If the small arc segment at the top is coloured,
the heating or cooling system is active.
If red - heating If blue - cooling
HOURS SETTING
This displays the number of hours for
which the manual mode is to apply.
From 1 hour (h01) to permanent (h∞)
FULL ARC
Appears when a setting is accepted
and when the heating or cooling
system is active
HUMIDITY DETECTED IN THE ATMOSPHERE
In this section you can opt to view the level
of humidity in the atmosphere (% RH)
%RH
Display of Relative Humidity currently
present in the atmosphere
ON/OFF SECTION
In this section you can turn
the thermostat ON or OFF
ON MODE
With ON mode selected, the thermostat
can function in either AUTO or Manual
modes
OFF MODE
With the OFF mode selected, the thermostat
will still maintain a frost protection setting of
+ 5 ° C to avoid freeze damage to the system
SETTINGS MENU
From here you can access the device settings
ASSOCIATION WITH THE GATEWAY
The opposing arrows will flash only during
the gateway pairing procedure
TRANSMISSION TEST WITH THE GATEWAY
At this point in the menu you can perform a signal
transmission test between the gateway and the
thermostat
RESULT OF THE TRANSMISSION TEST WITH THE GATEWAY
0
SIGNAL ABSENT: the gateway is unreachable
1/6 POOR: bring the two devices closer
7/8 GOOD: make changes only if errors are found
9/10 VERY GOOD: stable connection
FIRMWARE VERSION
At this point in the menu it is possible to view
the firmware version present on the device
BLISS2 user manual -
1