Epson ES-1000C - Business Scanning System 시작하기 - 페이지 6
{카테고리_이름} Epson ES-1000C - Business Scanning System에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ES-1000C - Business Scanning System 15 페이지. Product support bulletin(s)
Epson ES-1000C - Business Scanning System에 대해서도 마찬가지입니다: 시작하기 (29 페이지), 매뉴얼 (11 페이지), 제품 지원 게시판 (1 페이지), 제품 지원 게시판 (5 페이지)
페이지 인쇄
Connecting the Scanner to Your
Macintosh
Follow the steps below to connect the scanner directly to the
SCSI port on your Macintosh using the SCSI cable included
with the scanner. This cable has a 25-pin connector on one end
and a 50-pin connector on the other. The SCSI ID is already set
to 2 and the SCSI terminator is on.
If you are already using the SCSI port on your computer for
another SCSI device, such as an external hard disk, you need a
SCSI cable with a 50-pin connector on both ends. You can then
connect the scanner to your other SCSI device and set the SCSI
ID and terminator as necessary; follow the instructions in
Chapter 1 of your
1.
Turn off your Macintosh, scanner, and all peripheral devices.
2.
Plug the 25-pin connector into the SCSI port on the Macintosh
with a > icon above it. Tighten the two screws on the sides
of the connector.
3.
Connect the 50-pin end of the cable to either the top or
bottom SCSI connector on the scanner; then fasten the
connector with the wire clamps on its side.
4 Getting Started
ES-1000C User's Guide.
Caution:
Be sure that your Macintosh, scanner, and allperipheral
devices are turned off before you plug in the SCSI cable.