Epson ES-1200C Pro PC 제품 지원 게시판 - 페이지 3

{카테고리_이름} Epson ES-1200C Pro PC에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ES-1200C Pro PC 19 페이지. Product support bulletin(s)
Epson ES-1200C Pro PC에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지), 시작하기 매뉴얼 (31 페이지), 매뉴얼 (11 페이지), 시작하기 (17 페이지), 제품 지원 게시판 (5 페이지)

페이지 인쇄
Epson ES-1200C Pro PC 제품 지원 게시판
BASEDEV=OS2ASPI.DMD
BASEDEV=OS2SCSI.DMD
BASEDEV=AHAxxxx.ADD /V
DEVlCE=C:\OS2\MDOS\VASPl.SYS
NOTE:
This document assumes that you are using an Adaptec card. The AHA 1510 and
AHA1540C were tested when creating this document.
Once you have verified that the above lines are in the CONFIG.SYS, shut down
OS/2 and reboot.
NOTE:
If the SCSI card does not find any devices on the SCSI chain, the AHAxxxx.ADD
driver will not load thus causing VASPI.SYS not to load. If this occurs, double
check your card's configuration and the SCSI cabling.
Epson TWAIN v1.0x
Follow the steps below to enable Epson TWAIN v1.0x:
1.
From the OS/2 desktop, double click on the OS/2 SYSTEM folder
2.
Double click on the COMMAND PROMPTS folder
3.
Double click on the Win-OS/2 icon.
4.
Once Windows is loaded, follow the TWAIN installation procedure. When the
installation program asks if you wish to make changes to the CONFIG.SYS or
the CONFlG.ADD, select CONFIG.ADD.
5.
Once the installation has completed, exit Windows.
6.
If the COMMAND PROMPTS folder is not open, follow steps 1 and 2.
7.
Move the mouse to the WIN-OS/:! FULL SCREEN icon. Click on the right
mouse button.
8.
Select SETTINGS from the pop-up menu.
9.
Once the SETTINGS notebook has opened, click on SESSION.
10.
Click on the WIN-OS2 SETTINGS.
11.
Click on OTHER DOS SETTINGS.
12.
Click on OK.
13.
Highlight DOS-DEVICE.
14.
In the window to the right, add the EPSN.SYS driver. X represents the
appropriate SCSI ID of the scanner.
The device line would be entered in the following manner.
C:\EPSN.SYS 3 /Sx /i79
PSB No: P-0103A
Page: 3 of 4