Epson ES-1200C Pro PC 제품 지원 게시판 - 페이지 3

{카테고리_이름} Epson ES-1200C Pro PC에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ES-1200C Pro PC 5 페이지. Product support bulletin(s)
Epson ES-1200C Pro PC에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지), 시작하기 매뉴얼 (31 페이지), 제품 지원 게시판 (19 페이지), 매뉴얼 (11 페이지), 시작하기 (17 페이지)

페이지 인쇄

Select SETTINGS from the pop-up menu.

Once the SETTINGS notebook has opened, click on SESSION.

10.

Click on the WIN-OS2 SETTINGS.

11.

Click on OTHER DOS SETTINGS.

12.

Click on OK.

13.

Highlight DOS-DEVICE.

14.

In the window to the right, add the EPSN.SYS driver. X represents the

appropriate parallel port.

X = 0 (Parallel port address 3BCh)

X = 1 (Parallel port address 378h)

X = 2 (Parallel port address 278h); This is the default setting Epson TWAIN

uses.

The device line would be entered in the following manner. Substitute 0, 1 or 2

based on your configuration.

C:\EPSN.SYS x /i79

15.

Click on SAVE.

16.

Close the SETTINGS notebook.

The next time a Win-OS/2 session is started, you will see the EPSON device driver

load. If you do not, repeat the above steps. If you have migrated a Windows

application to the OS/2 desktop, apply the above steps to that icon instead of the

Win-OS/2 icon. To verify that the configuration is correct, configure the DOS FULL

SCREEN icon using the same methods outlined in steps 6 through 16. Once you

have completed those steps, start a DOS FULL SCREEN session and run the

SCANTEST utility from the \WlNDOWS\TWAIN directory. If SCANTEST runs

successfully, chances are that the Windows session will run properly.

SCSI Interface

In order for either of the Epson TWAIN drivers to function in a Windows session

under OS/2, you must install support for your ASPI compliant SCSI card under

OS/2 first. For installation instructions, refer to your OS/2 manual.

Once you have installed support for your ASPI compliant card under OS/2, you

need to manually check the CONFIG.SYS file for four key files. You should have

the following lines in the OS/2 CONFIG.SYS. If these lines do not exist, add them.

The AHAxxxx.ADD should have been inserted when you installed the SCSI support

for OS/2.

PSB No: P-0103A

Page: 2 of 4