Epson ES-300C 제품 지원 게시판
{카테고리_이름} Epson ES-300C에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ES-300C 19 페이지. Laser & non-impact printer error codes
Epson ES-300C에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 보충 설명서 (15 페이지), 매뉴얼 (11 페이지), 제품 지원 게시판 (20 페이지), 제품 지원 게시판 (14 페이지), 제품 지원 게시판 (25 페이지), 제품 지원 게시판 (13 페이지)
페이지 인쇄
EPSON AMERICA, INC.
Product Support Bulletin
Subject: OS/2 Warp 3.0 and Epson TWAIN
Date: 1/26/95
Page(s): 1 of 4
This bulletin describes the necessary steps to implement the Epson TWAIN driver
in a Windows 3.1 session under OS/2 Warp 3.0. This procedure will cover both
current versions of Epson TWAIN (1.03 and lower as well as 2.02 and higher) using
bidirectional parallel and SCSI interfaces.
NOTE:
TWAIN v1.03 and lower will not work with the Epson ES-1200C scanner. You must
use TWAIN 2.02 or higher. If you are using the ES-1200C with a program that has
Epson scanner support, you may need install the EPSN.SYS device driver for that
Windows session. To do this, follow steps 6 through 16 below. You will need to
obtain EPSNSY.EXE from the Epson BBS. This file has the EPSN.SYS driver
included in it. Simply copy the driver to the root directory of your boot drive.
Bidirectional Parallel Interface
Epson TWAIN v2.xx
There is no special procedure required to setup this version of the driver to run in a
Windows session under OS/2 Warp 3.0. Simply launch Windows and install the
driver.
Epson TWAIN v1.0x
Follow the steps below to enable Epson TWAIN v1.0x:
1.
From the OS/2 desktop, double click on the OS/2 SYSTEM folder
2.
Double click on the COMMAND PROMPTS folder
3.
Double click on the Win-OS12 icon.
4.
Once Windows is loaded, follow the TWAIN installation procedure. When the
installation program asks if you wish to make changes to the CONFIG.SYS or
the CONFIG.ADD, select CONFIG.ADD.
5.
Once the installation has completed, exit Windows.
6.
If the COMMAND PROMPTS folder is not open, follow steps 1 and 2.
7.
Move the mouse to the WIN-OS/2 FULL SCREEN icon. Click on the right
mouse button.
PSB No: P-0103A
Originator: CEB