Epson ES-300GS 시작하기 - 페이지 5

{카테고리_이름} Epson ES-300GS에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ES-300GS 16 페이지. Personal document station grayscale scanner
Epson ES-300GS에 대해서도 마찬가지입니다: 사용자 설명서 (5 페이지)

페이지 인쇄

Setting Up the Scanner

Follow the steps below to set up the scanner and connect it to

the SCSI port on your Macintosh or to another SCSI device.

The SCSI cable included with the scanner has a 25-pin

connector on one end and a dual 25-/50-pin connector on the

other.

50-pin connector for an additional device

25-pin connector to the scanner

1. Take the scanner out of its box and place it on a flat, stable

surface with the rear panel facing you.

2. Remove the tape securing the scanner cover and pull out

any packing material from underneath the cover.

3. Turn off your Macintosh, scanner, and any other peripheral

devices. The scanner is turned off when the O side of the

power switch on the rear panel is pressed down.

Caution:

Be sure that your Macintosh, scanner, and any other

peripheral devices are turned off before you plug in any

cables.

4. The scanner's default SCSI ID setting is 2. If you need to

change the scanner to another SCSI ID, press the plus or

minus button next to the SCSI port until you see the desired

number in the display. (Be sure you do not select a number

assigned to another device.)

Getting Started