Cisco UCS 82598KR 매뉴얼 - 페이지 2

{카테고리_이름} Cisco UCS 82598KR에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS 82598KR 14 페이지.

Prerequisites

Cisco recommends that you have knowledge of Cisco UCS Server Blade hardware administration.

The information in this document is based on the Cisco UCS.

The information in this document was created from the devices in a specific lab environment. All of the

devices used in this document started with a default configuration. If your network is live, make sure that you

understand the potential impact of any command.

This document uses this network setup, which is a typical Cisco UCS topology:

Refer to the Cisco Technical Tips Conventions for more information on document conventions.

vNICs and vHBAs are the trickiest part of service profiles. vNICs are identified on MAC and vHBA are

identified on WWN.

For adapters with only physical NICs, for example, Cisco UCS CNA M71KR and Cisco UCS 82598KR, you

must create a vNIC for each NIC you want to make usable on the network within Cisco UCS. Then vNIC has

a switch setting and a failover flag. For Cisco UCS 82598KR, you must match the physical setting so that the

first adapter goes to Fabric Interconnect A and the second to Fabric Interconnect B, and you cannot choose

failover. For Cisco UCS CNA M71KR, each vNIC is associated with a particular Fabric Interconnect, but you

can enable failover.