B2 Audio Zero1 소유자 매뉴얼 - 페이지 4
{카테고리_이름} B2 Audio Zero1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. B2 Audio Zero1 10 페이지.
페이지 인쇄2. Panel layout
Zero1
INPUT
Signal input from the head unit. A minimum level
input of 0.2V is essential for correct operation.
POWER & PROTECTION INDICATOR
Power LED, Blue-lit shows correct operation.
Protect LED, Red-lit shows general malfunction,
faulty connection or thermal protection.
GAIN (6V ~ 0.2V)
Matching of the output voltage from the head unit's
RCA line-outs to the input section.
SUBSONIC FILTER (10Hz ~ 50Hz @ 24dB/Oct)
Adjusts the subsonic cut off point to eliminate
frequencies within the filter's range.
SPEAKER OUTPUTS
Amplifier connection to the loudspeakers.
Minimum speaker cable is 12 gauge.
Minimum impedance for the
used as a single unit.
In a daisy chain configuration the minimum
impedance is 2
.
BASS
BASS
BOOST
FREQ
0dB 9dB
30Hz 80Hz
Zero1
is 1
if
MASTER
SLAVE1
SLAVE2
SWEET LIKE DANISH
BASS BOOST
Variable bass boost with 0-9dB .
BASS FREQ
Variable bass boost frequency from 30Hz ~ 80Hz
LOW PASS FILTER (35Hz ~ 250Hz @ 24dB/Oct)
Adjusts the cut off point for the low pass filter
within the filter's range.
PHASE CONTROL
Variable phase adjustment from 0-180 degrees.
REMOTE LEVEL CONTROL PORT
Connection of external level control.
(The
Better Bass Remote
can be connected for additional features).
OUTPUT MASTER / INPUT SLAVE
For daisy chain connection of 2 Zero1 amplifiers.
Minimum impedance is 2
Output signal can be routed from 1 master amplifier
to 2 slave amplifiers, by setting the switch to SLAVE1
& SLAVE2 on the amplifiers in question.
DO NOT USE IN DAISY CHAIN MODE!
4
.