Epson ES-600C 사용자 설명서 - 페이지 3

{카테고리_이름} Epson ES-600C에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ES-600C 5 페이지. Product support bulletin(s)
Epson ES-600C에 대해서도 마찬가지입니다: 시작하기 (13 페이지), 보충 설명서 (15 페이지), 매뉴얼 (11 페이지), 제품 지원 게시판 (5 페이지), 제품 지원 게시판 (8 페이지)

페이지 인쇄
Epson ES-600C 사용자 설명서

Dip Switches

Default setting: All Off

Pin Assignments

Parallel
Signal pin assignments
Pin
Return
Signal
Direction
No.
pin
1
19
STROBE
2
20
DATA0
IN/OUT
3
21
DATA1
IN/OUT
4
22
DATA2
IN/OUT
5
23
DATA3
IN/OUT
6
24
DATA4
IN/OUT
7
25
DATA5
IN/OUT
8
26
DATA6
IN/OUT
9
27
DATA7
IN/OUT
10
28
ACKNLG OUT/(IN)
11
29
BUSY
OUT/(IN)
Scanners
STROBE pulse to read in or
send out data. Pulse width must
be more than 0.5 microseconds
at the receiving terminal.
These signals represent
information of bits 1 to 8,
respectively. Each signal is at a
high level when data is logical 1
and low when it is logical 0.
About a 12-microsecond pulse.
Low indicates that data has been
received and that the scanner is
ready to accept more data.
When this signal is high, the
scanner cannot receive data.
The signal is high:
1) during data entry
2) during scanning
3) when the scanner is not
ready
4) when the scanner has an
error
connected at signal ground level. For interface wiring, be sure to use a
twisted-pair cable for each signal, and to complete the connection on
the return side. These cables should be shielded and the ground
connected to the chassis of the host computer and the scanner.
SCSI
Signal pin assignments
11/2/92
microseconds at the
ES-600C-3