Cisco UCS B200 M3 설치 및 서비스 참고 사항 - 페이지 10
{카테고리_이름} Cisco UCS B200 M3에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B200 M3 36 페이지. Blade server
Cisco UCS B200 M3에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 설치 및 서비스 참고 사항 (37 페이지), 매뉴얼 (8 페이지), 업그레이드 매뉴얼 (21 페이지), 설치 및 서비스 참고 사항 (28 페이지)
페이지 인쇄
Installing and Removing a Blade Server Hard Drive
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
RAID volumes. If drives of different capacities are used, the useable portion of the smallest drive will
be used on all drives that make up the RAID volume. Before upgrading or adding an HDD to a running
system, check the service profile in UCS Manager to make sure that the new hardware configuration is
within the parameters allowed by the service profile.
Hard disk and RAID troubleshooting information is in the "Troubleshooting Server Hardware" chapter
of the
B200 M3 servers if needed.
Table 2
drive sled attached. Spare drive sleds are not available.
Table 2
Product ID
HDDs
A03-D1TBSATA
UCS-HDD900GI2F106
A03-D600GA2
A03-D500GC3
UCS-HDD300GI2F105
A03-D300GA2
A03-D146GC2
SSDs
UCS-SD300G0KA2-E
UCS-SD200G0KA2-E
UCS-SD100G0KA2-E
Removing a Blade Server Hard Drive
To remove a hard drive from a blade server, follow these steps:
Step 1
Push the button to release the ejector, and then pull the hard drive from its slot.
Cisco UCS B200 M3 Blade Server Installation and Service Note
10
Cisco UCS Troubleshooting
shows the drives supported in this blade server. They are all hot pluggable and come with the
Supported Drives
Description
1 TB 6 Gb SATA 7.2K RPM SFF HDD
900GB 6Gb SAS 10K RPM SFF HDD
600 GB 6 Gb SAS transfer rate, 10K RPM SFF HDD
500GB 6Gb SATA 7.2K RPM SFF HDD
300 GB 6 Gb SAS transfer rate, 15K RPM SFF HDD
300 GB 6Gb SAS 10K RPM SFF HDD
146 GB 6 Gb SAS transfer rate, 15K RPM SFF HDD
300GB Std Height 15mm SATA SSD
200 GB Std Height 15 mm SATA SSD
100 GB Std Height 15 mm SATA SSD
Guide. This provides a procedure for moving a RAID array between
OL-26624-01