Cisco UCS B200 M3 설치 및 서비스 참고 사항 - 페이지 33

{카테고리_이름} Cisco UCS B200 M3에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B200 M3 37 페이지. Blade server
Cisco UCS B200 M3에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 설치 및 서비스 참고 사항 (36 페이지), 매뉴얼 (8 페이지), 업그레이드 매뉴얼 (21 페이지), 설치 및 서비스 참고 사항 (28 페이지)

TPM installation is supported after-factory. However, a TPM installs with a one-way screw and cannot

Note

be replaced or moved to another server. If a server with a TPM is returned, the replacement server must

be ordered with a new TPM.

Procedure

Step 1

Install the TPM hardware.

a) Power off, decommission, and remove the blade server from the chassis.

b) Remove the blade server cover.

c) Install the TPM to the TPM socket on the server motherboard and secure it using the one-way screw that is provided.

See the figure below for the location of the TPM socket.

d) Return the blade server to the chassis, power it on, and allow it to be automatically reacknowledged, reassociated, and

recommissioned.

e) Continue with enabling TPM support in the server BIOS in the next step.

Figure 24: TPM Socket Location

Front of server

Step 2

Enable TPM Support in the BIOS.

a) Enable Quiet Mode in the BIOS policy of the server's service profile.

b) Establish a direct connection to the server, either by connecting a keyboard, monitor, and mouse to the front panel

using a KVM dongle (N20-BKVM) or by other means.

c) Reboot the server.

d) Press F2 during reboot to enter the BIOS setup screens.

e) On the Advanced tab, select Trusted Computing and press Enter to open the TPM Security Device Configuration

window.

f) Set the TPM Support option to Enabled.

TPM socket on motherboard