Cisco UCS B22 M3 업그레이드 매뉴얼 - 페이지 12

{카테고리_이름} Cisco UCS B22 M3에 대한 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B22 M3 21 페이지. Blade server
Cisco UCS B22 M3에 대해서도 마찬가지입니다: 설치 및 서비스 참고 사항 (31 페이지)

페이지 인쇄

Cisco UCS Blade Server

Upgrade Scenario 3: UCSM at Version 2.2(2c) or Later, CPU is Intel E5-2400 v2, BIOS on Spare Earlier

Than Version 2.2(2c)

This scenario is unique to a field-service situation in which a server that is already running Intel

E5-2400 v2 Series CPUs must be replaced, but the only replacement server available is running a BIOS

earlier than 2.2(2c).

This scenario assumes the following conditions:

•

Use the following procedure to upgrade the replacement server BIOS to the required version:

Disassociate the server in Cisco UCS Manager.2.2(2c)

Step 1

Power off the server.

Step 2

Transfer the CPUs from the old server to the new replacement server.

Step 3

Use the procedures in the

Insert the server into the chassis that is running Cisco UCS Manager 2.2(2c) or later.

Step 4

Note

Use the Cisco UCS Manager CLI to upgrade the BIOS. Use the following sequence of commands:

Step 5

Note

# scope server <chassis/blade>

chassis/server # scope bios

chassis/server/bios # show image

chassis/server/bios # update firmware <server_model>.<firmware version>

chassis/server/bios* # commit-buffer

Wait for the update to complete. Check the status of the update and wait until the following command

Step 6

returns

chassis/server/bios # show update status

Status: Ready

Step 7

Activate the new BIOS:

chassis/server/bios # activate firmware <server_model>.<firmware version>

Warning: When committed this command will reset the end-point

chassis/server/bios* # commit-buffer

chassis/server/bios # exit

Power-cycle the server to get discovery out of the hang state:

Step 8

chassis/server # cycle cycle-immediate

chassis/server* # commit-buffer

Cisco UCS B-Series Servers Upgrade Guide for Intel E5-2600/E5 2400 v2 Series CPUs

The Cisco UCS Manager software is at version 2.2(2c) or later.

The replacement server is using Intel E5-2400 v2 Series CPUs (after the CPUs are transferred from

the old server).

The replacement server is using BIOS/CIMC version earlier than 2.2(2c).

Blade Server Installation and Service Note

The server does not boot and discovery of the server hangs waiting for BIOS POST to complete

because the BIOS is at an earlier version that does not support E5-2400 v2 Series CPUs.

The

command in the sequence below lists the firmware versions available for the

show image

server. Always activate the latest firmware image version when you use the

command.

update firmware

. It takes a few minutes for the Status to return Ready.

Status: Ready

for your server.

OL-28629-02