Cisco UCS B420 M3 설치 및 서비스 참고 사항 - 페이지 7

{카테고리_이름} Cisco UCS B420 M3에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B420 M3 38 페이지. High performance blade server
Cisco UCS B420 M3에 대해서도 마찬가지입니다: 업그레이드 매뉴얼 (8 페이지)

페이지 인쇄

Installing a Blade Server Hard Drive

To install a hard drive in a blade server, follow these steps:

Procedure

Step 1

Place the hard drive lever into the open position by pushing the release button.

Step 2

Gently slide the hard drive into the opening in the blade server until it seats into place.

Step 3

Push the hard drive lever into the closed position.

You can use Cisco UCS Manager to format and configure RAID services. For details, see the Configuration Guide for the

version of Cisco UCS Manager that you are using. The configuration guides are available at the following URL:

www.cisco.com/en/US/products/ps10281/products_installation_and_configuration_guides_list.html

If you need to move a RAID cluster, see the

Blade Server Removal and Installation

Before performing any internal operations on this blade server, you must remove it from the chassis.

Caution

To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by the

carrier edges only.

Powering Off a Blade Server

You can also shut down servers remotely using Cisco UCS Manager or CIMC. For details, see the

Tip

Configuration Guide for the version of Cisco UCS Manager that you are using. The configuration guides

are available at the following URL:

and_configuration_guides_list.html

Procedure

Step 1

If you are local to the server, check the color of the Power Status LED for each server in the chassis that you want to

power off.

• Green indicates that the server is running and must be shut down before it can be safely powered off. Go to Step 2.

• Amber indicates that the server is already in standby mode and can be safely powered off. Go to Step 3.

Step 2

If you previously enabled front power button control through Cisco UCS Manager, press and release the Power button,

then wait until the Power Status LED changes to amber. Otherwise, you cannot press the front power button because it

is disabled by default.

Cisco UCS Manager Troubleshooting Reference

http://www.cisco.com/en/US/products/ps10281/products_installation_

http://

Guide.