Cisco UCS B460 M4 설치 및 서비스 참고 사항 - 페이지 42

{카테고리_이름} Cisco UCS B460 M4에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B460 M4 46 페이지. Blade server
Cisco UCS B460 M4에 대해서도 마찬가지입니다: 데이터시트 (7 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (5 페이지), 설치 및 서비스 참고 사항 (50 페이지)

페이지 인쇄

Removing the Scalability Terminator

Upgrading to the UCS B460 M4 blade server requires that you remove the UCS Scalability Terminator from

a UCS B260 M4 blade server. If you do not plan to upgrade to a UCS B460 M4 Blade Server, you should not

need to remove the UCS Scalability Terminator from a UCS B260 M4 Blade Server.

Before You Begin

Decommission the blade server using Cisco UCS Manager to take the server offline.

Procedure

Step 1

Completely loosen the captive screws on the front of the UCS Scalability Terminator. See callout 1 in the

following figure.

Step 2

Open both ejector levers on the front of the UCS Scalability Terminator. See callout 2 in the following figure.

Step 3

While holding the ejector levers open, pull the UCS Scalability Terminator away from the blade server to

separate it from the blade server. See callout 3 in the following figure.

Step 4

Once removed, place the UCS Scalability Terminator on an antistatic mat or antistatic foam.

Figure 25: Removing the Scalability Terminator

Installing a Scalability Connector

Use a UCS Scalability Connector to connect together two UCS Scalable M4 Blade Modules and form the

UCS B460 M4 Blade Server.

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs

Upgrading to a Cisco UCS B460 M4 Blade Server