Cisco UCS B460 M4 설치 및 서비스 참고 사항 - 페이지 27

{카테고리_이름} Cisco UCS B460 M4에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B460 M4 50 페이지. Blade server
Cisco UCS B460 M4에 대해서도 마찬가지입니다: 데이터시트 (7 페이지), 설치 및 서비스 참고 사항 (46 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (5 페이지)

페이지 인쇄

Servicing the Blade Server

Note

• A squeeze-to-remove retaining clip is provided to secure the internal USB flash memory. The clip must

• Use of this server may require an upgrade to the FEX in the chassis. The Cisco 2104XP fabric extender

Diagnostics Button and LEDs

At blade start-up, POST diagnostics test the CPUs, DIMMs, HDDs, and rear mezzanine modules, and any

failure notifications are sent to Cisco UCS Manager. You can view these notifications in the Cisco UCS

Manager System Error Log or in the output of the show tech-support command. If errors are found, an amber

diagnostic LED also lights up next to the failed component. During run time, the blade BIOS and component

drivers monitor for hardware faults and will light up the amber diagnostic LED as needed.

LED states are saved, and if you remove the blade from the chassis the LED values will persist for up to 10

minutes. Pressing the LED diagnostics button on the motherboard causes the LEDs that currently show a

component fault to light for up to 30 seconds for easier component identification. LED fault values are reset

when the blade is reinserted into the chassis and booted, and the process begins from its start.

If DIMM insertion errors are detected, they may cause the blade discovery process to fail and errors will be

reported in the server POST information, which is viewable using the UCS Manager GUI or CLI. DIMMs

must be populated according to specific rules. The rules depend on the blade server model. Refer to the

documentation for a specific blade server for those rules.

Faults on the DIMMs or rear mezzanine modules also cause the server health LED to light solid amber for

minor error conditions or blinking amber for critical error conditions.

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v3 and E7 v2 CPUs

Internal USB connector

A Cisco USB drive is

recommended, but if you

use another USB drive, it

must be no wider than 0.8

inches (20 mm), and no

more than 1.345 inches

(34 mm) long in order to

provide needed clearances

to install or remove the

USB device. USB flash

memory from sources

other than Cisco is

allowed, but is not

supported by Cisco and is

used at the user's risk.

always be securely fastened when the flash memory is in use. Memory that does not fit in the clip should

not be used.

is not compatible when any Cisco-certified adapter is installed in slot 1 or slot 2. If a Cisco VIC 1240

modular LOM card is installed, you will have connectivity through the mLOM but other adapters will

not be recognized.