finder 12.21.8.230.0000 매뉴얼 - 페이지 13

{카테고리_이름} finder 12.21.8.230.0000에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. finder 12.21.8.230.0000 17 페이지. Time switches 16 a

페이지 인쇄

Functions type 12.51

Program mode (daily)

In this mode it is possible to set the "pattern" of time segments, which define the ON time of the 11-14

output contact. This "pattern" will be the same for all days of the week (daily).

Entering Programming mode (from Display mode) with a short press to

00:00 (and any previously programmed segment pattern is displayed). Stepping backwards

forwards

in time displays the appropriate segment time and the appropriate open or closed contact

status for that time segment.

At any step it is possible to change the segment status with a short press to the joystick

(for OFF) as appropriate, and this also automatically advances the time to the next segment, and

always in a clockwise direction. If the joystick is pressed several times in, say, the

each successive segment will assume the ON status. If it is then pressed several times in the

direction then each successive segment will assume the OFF status. This allows the rapid setting of

many consecutive segments with the same status.

A short press to the joystick centre

Program mode (weekly)

In this mode it is possible to set a different "pattern" of time segments for each day of the week (weekly).

Entering Programming mode (from Display mode) with a short press to

programming mode, for the current day. With a subsequent short press to

from one day to another (Monday is day 1).

With the desired day selected it is possible to enter the programming mode for that day by pressing

Program the segments for that day by following the same procedure as described above for daily mode.

When all 48 segments have been set, accept with a short press to

pressing the joystick in the

other remaining days.

At any time return to the Display mode with a short press to the joystick centre

COPY FUNCTION

View the particular day to be copied (using

(the "copy icon" will then appear).

Then select another day, using

This can be repeated for other days.

A short press to the joystick centre

Power-save mode

If the 230 V AC supply is not connected, the time switch enters power-save mode: only the clock is

maintained active whilst the display turns off so as to guarantee a long life for the built-in back-up

battery.

With a press to the joystick it is possible to "awake" the device and enter Display mode (with the "plug"

symbol displayed). A further press to

Display mode section above.

After about 1 minute of inactivity the power-save mode will start again. During program or set-up the

current absorption is higher than in power-save mode, thus influencing the battery life.

In this mode the display back-light is not active. It is activated following a press to the joystick only with

the 230 V AC supply connected, but after about 1 minute of inactivity the display back-light will turn off,

and to activate it again it is necessary to press the joystick again.

12 Series - Time switches 16 A

will restore the display to the Display mode.

direction. Repeat programming for the next day, and then repeat for

as described above) and copy with a short press to

, and paste the copied program with a short press to

, or

, will exit the copy function.

will enter the program or set-up mode as explained in the

takes the digital time to

(for ON) or

direction then

takes the display to the

it is possible to pass

. Then progress to the next day by

SERIES