Acuity nLight 빠른 시작 매뉴얼

{카테고리_이름} Acuity nLight에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acuity nLight 4 페이지. Digital time clock

nLight® Digital Time Clock (DTC)

Quick Start Guide

Welcome to the nLight Digital Time Clock (DTC) Quick Start Guide. This guide provides a quick explanation of how to properly mount, configure,

and create schedules on your new DTC device.

Mounting Instructions

To mount, the faceplate must be detached from the

backplate. This will require an appropriately sized tool

(i.e., flat-head screwdriver) that can fit in the release tab.

Pull the backplate out from the bottom, away from the

faceplate, as pictured.

Pull all wires out of the wall and run them through the

central hole of the backplate. Screw the backplate onto

the wall.

Using the appropriately sized tool, press in the release tabs on each side of the device

until the backplate is noticeably released.

Device should be separated into two pieces, backplate and faceplate.The backplate will

be used to mount onto a wall gang box.

Plug the wire(s) into the connector(s), then gently push the excess wiring back into the

wall. Reattach the front plate and ensure that it clips tightly in place. Tighten thesecurity

screw, if applicable.

1 of 4