Cisco UCS C240 M3 구성 매뉴얼 - 페이지 31
{카테고리_이름} Cisco UCS C240 M3에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS C240 M3 33 페이지. Nebs server
Cisco UCS C240 M3에 대해서도 마찬가지입니다: 업그레이드 매뉴얼 (10 페이지), 서비스 참고 사항 (11 페이지)
General Parameters
Following are some general parameters for MegaCLI:
Adapter parameter –aN
●
The parameter –aN, where N is a number starting with zero or the string ALL, specifies the adapter ID. If
you have only one controller, you can safely use ALL instead of a specific ID, but you're encouraged to use
the ID for anything that makes changes to your RAID configuration.
Physical drive parameter –PhysDrv[E:S]
●
For commands that operate on one or more physical drives, the parameter –PhysDrv[E: S] is used, where E
is the enclosure device ID in which the drive resides, and S is the slot number (stating with 0). The
enclosure device ID can be determined by using the command MegaCli –Enclinfo –aALL. The [E: S]
syntax is also used to specify the physical drives when you create a new RAID virtual drive
Virtual drive parameter –Lx
●
The parameter –Lx is used for specifying the virtual drive, where x is a number starting with 0 or the string
ALL.
Command Syntax
This section presents the syntax for common MegaCLI commands.
Commands to Get Information
●
Controller information:
MegaCli –AdpAllInfo –aALL
MegaCli –CfgDsply –aALL
MegaCli –adpeventlog –getevents –f lsi-events.log –a0 –nolog
●
Enclosure information:
MegaCli –EncInfo –aALL
●
Virtual drive information:
MegaCli –LDInfo –Lall –aAll
●
Physical drive information:
MegaCli –PDList –aAll
MegaCli –PDInfo –PhysDrv [E: S] –aALL
Commands for Virtual Drive Management
●
Create a RAID volume based on a single drive group (RAID 0, RAID 1, or RAID 5):
MegaCli –CfgLdAdd –r (#raid level#) [E: S] –aN
●
Create a RAID volume based on double drive groups (RAID 10 or RAID 50):
MegaCli –CfgSpanAdd –r (#Raid level#) –Array0 [E: S, E: S] –Array1 [E: S, E: S] –aN
Figure 13 shows the creation of a double-drive-group RAID volume.
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 31 of 33