Epson Expression 636 제품 정보 매뉴얼 - 페이지 2
{카테고리_이름} Epson Expression 636에 대한 제품 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Expression 636 5 페이지. Product support bulletin(s)
Epson Expression 636에 대해서도 마찬가지입니다: 설정 매뉴얼 (36 페이지), 간편한 설정 매뉴얼 (21 페이지), 소프트웨어 설명서 (4 페이지), 매뉴얼 (11 페이지), 제품 지원 게시판 (14 페이지), 제품 지원 게시판 (5 페이지)
페이지 인쇄
EPSON Expression 636
Electrical Specifications
Input voltage
100-120 VAC, f 10%
range:
Rated frequency:
to 60 Hz
50
Input frequency:
to 60.5 Hz
49.5
Rated current:
A
0.8
Power
Approx. 25 W (self-test mode without
consumption:
optional unit), 50 W maximum with
optional unit
Insulation
10 Ma between AC power line and
resistance:
chassis at 500 VDC
Environmental Conditions
Temperature:
Operation: 41" F to 95" F (5' C to 35" C)
Storage: -13" F to 140" F (-25" C to 60" C)
Humidity:
Operation: 10% to 80%, without
condensation
Storage: 10% to 85%, without
condensation
Operating
Ordinary office or home conditions.
conditions:
Extremely dusty conditions should be
avoided.
Operation under direct sunlight or near
a strong light source should be avoided.
Note:
Specifications are subject to change without notice.
Parallel Interface Specifications
Interface type:
Bidirectional parallel interface
Data format:
S-bit parallel
Synchronization:
By external strobe pulse
Handshaking:
By ACKNLG and BUSY signals
Logic level:
Input/output data and interface control
signals are TTL compatible
Connector type:
36-pin Centronics@ type connector
EPSON Expression 636-2
Connector pin
arrangement:
Pin assignments for
the bidirectional parallel
interface:
I Signal
I 19-30
I
.
GND
Ground
II
31
I
I
I
32
N C
33
GND
N C
36
DIR
I
SCSI Specifications
Interface type:
ANSI X3.131-1986 standard
Function:
BUS FREE phase
ARBITRATION phase
SELECTION/RESELECTION phase
COMMAND phase
(Logical Unit Number is fixed at 0
and command link function is not
supported.)
DATA phase
Data in phase
Data out phase
STATUS phase
MESSAGE phase
MESSAGE IN phase
MESSAGE OUT phase
ATTENTION condition
RESET condition
I
Scanner reset sianal. The oulse width
than 50 ps.
Not used
Ground
Not used
Direction
Scanners