Cisco 1100 Series 설치 및 업그레이드 - 페이지 3

{카테고리_이름} Cisco 1100 Series에 대한 설치 및 업그레이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1100 Series 15 페이지. Terminal gateway
Cisco 1100 Series에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지), 하드웨어 설치 매뉴얼 (44 페이지)

페이지 인쇄

Installing and Upgrading Internal Modules and FRUs

Replacing the Cover

To replace the cover, perform the following steps.

Step 1

Read the

Safety Warnings, on page 1

Step 2

Confirm the router is turned off and disconnected from the power supply or power supplies. If a redundant power is used

disconnect from the redundant power supply.

Step 3

Place the chassis on a flat surface.

Step 4

Locate the cover hooks on the mating slots and slide the cover towards the bezel side.

Step 5

Install seven screws on each side.

Locating Internal and External Slots for Modules

This section describes the locations of internal modules on the router motherboard. Internal modules include

PoE daughter card on the Cisco1100 Series ISRs.

Figure 2: Module Location in the Cisco 1100 Series ISR

Screw holes (7 numbers on each side)

and disconnect the power supply before you begin.

Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router

Locating Internal and External Slots for Modules