Cisco 1700 series 매뉴얼

{카테고리_이름} Cisco 1700 series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1700 series 15 페이지. Secure firewall management center
Cisco 1700 series에 대해서도 마찬가지입니다: 규정 준수 및 안전 정보 매뉴얼 (45 페이지), 구성 매뉴얼 (25 페이지), 애플리케이션 노트 (41 페이지), 하드웨어 문제 해결 (12 페이지), 개요 매뉴얼 (13 페이지), 구성 (34 페이지), 매뉴얼 (5 페이지), 빠른 시작 매뉴얼 (6 페이지), 하드웨어 설치 매뉴얼 (46 페이지)

ROM Monitor

This appendix describes the Cisco router ROM monitor (also called the bootstrap

program). The ROM monitor firmware runs when the router is powered up or

reset. The firmware helps to initialize the processor hardware and boot the

operating system software. You can perform certain configuration tasks, such as

recovering a lost password or downloading software over the console port, by

using the ROM monitor. If there is no Cisco IOS software image loaded on the

router, the ROM monitor runs the router.

This appendix contains the following sections:

Entering the ROM Monitor

To use the ROM monitor, you must be using a terminal or PC that is connected to

the router by means of the console port. Refer to the installation chapter in the

Hardware Installation Guide for your router, for information about connecting the

router to a PC or terminal.

78-5407-03

Entering the ROM Monitor

•

ROM Monitor Commands

•

Command Descriptions

•

Disaster Recovery with TFTP Download

•

Configuration Register

•

Console Download

•

A P P E N D I X

Cisco 1700 Series Router Software Configuration Guide

B-1