Before you begin, disconnect all WAN cables from the router to keep it from running the AutoInstall
process. The router tries to run AutoInstall whenever you power it on if there is a WAN connection on
both ends and the router does not have a valid configuration file stored in NVRAM (for instance, when
you add a new interface). It can take several minutes for the router to determine that AutoInstall is not
connected to a remote Transmission Control Protocol/Internet Protocol (TCP/IP) host.
To enter configuration mode, follow this procedure:
Step 1
Connect a console to the router. If you need instructions for connecting a console, refer to the
installation chapter of your router installation and configuration guide. Power up the router.
Step 2
If the current configuration is no longer valid, after about one minute you see the following prompt:
Would you like to enter the initial dialog? [yes]:
Enter no. You now enter the normal operating mode of the router.
Note
After a few seconds, you see the user EXEC prompt. Type enable and the password to enter enable
Step 3
mode:
Router> enable
Password:
Configuration changes can be made only in enable mode. The prompt changes to the privileged EXEC
(enable) prompt (
Router#
Enter the config terminal command to enter configuration mode:
Step 4
Router# config terminal
Router(config)#
The router enters global configuration mode, indicated by the
If you have not configured the router before or want to change the configuration, you can configure
Step 5
global parameters, passwords, network management, and routing protocols. In this example, IP routing,
AppleTalk routing, and Internetwork Packet Exchange (IPX) routing are all enabled:
Router(config)# ip routing
Router(config)# appletalk routing
Router(config)# ipx routing
For complete information about global configuration commands, refer to the IOS configuration guides
and command references.
Select the ADSL interface to configure:
Step 6
Router(config)# interface atm 0
Router(config-if)#
The prompt changes again to show that you are in interface configuration mode.
Note
Select the ADSL operating mode:
Step 7
OL-3317-03
If the current configuration is valid, you enter the normal operating mode automatically.
):
Router#
For the Cisco 1751 and 1760 routers, enter the command as interface atm slot/port. For
example, interface atm 0/0.
Configuring an ADSL WAN Interface Card on Cisco 1700 Series Routers
Configuring the ADSL Interface
prompt.
Router(config)#
9
페이지 인쇄