Cisco 2600 Series 설치 매뉴얼 - 페이지 9

{카테고리_이름} Cisco 2600 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2600 Series 12 페이지. Configuring adsl wic to support pppoe clients
Cisco 2600 Series에 대해서도 마찬가지입니다: 릴리스 정보 (32 페이지), 구성 (15 페이지), 애플리케이션 노트 (41 페이지), 데이터시트 (6 페이지), 부록 (15 페이지), 설치 매뉴얼 (22 페이지), 개요 (13 페이지), 빠른 시작 매뉴얼 (2 페이지), 매뉴얼 (5 페이지)

페이지 인쇄
Cisco 2600 Series 설치 매뉴얼
Align the Cisco RPS Adapter Plate with the chassis cutout for the power supply. Tilt the
Step 3
adapter plate slightly toward you at the top, and rock it up and into place, ensuring that
the two small hooks at the top of the Adapter Plate engage the router chassis. (See
Figure 9.)
Figure 9
Installing the Cisco RPS Adapter Plate
Install the mounting screw that came with the Cisco RPS Adapter Plate into the screw
Step 4
hole. (See Figure 10.)
Figure 10
Installing the Mounting Screw
DC INPUT FOR USE WITH CISCO RPS
+5V– – –10A, +12V– – –2A, -12V– – –1A
Mounting
screw
Connect the six-pin connector to the system board. The connector is keyed so that it
Step 5
cannot be connected to the system board incorrectly. (See Figure 11.)
Step 6
Connect the 4-pin environmental status connector only if your router, with the connector
connected, has been upgraded to the correct level of Cisco IOS software. Using any other
level of Cisco IOS software can cause the router to crash. Cisco IOS Release 11.1(12)AA
or later is compatible but will not show status from the RPS. Cisco IOS Release 11.2(7)P
or later will provide RPS status information to the network.
Installing the Redundant Power Supply Adapter Plate
Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers
Front of chassis
9