B3 innovations Pico 매뉴얼 - 페이지 5

{카테고리_이름} B3 innovations Pico에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. B3 innovations Pico 12 페이지.

Ensure Proper Alignment

with Extruder

While Pico is cool, use a straight 3mm or 1.75mm

section of plastic filament or rod made of non-abrasive

material (to prevent scratching inner bore) to check for

a smooth transition between Pico hot-end and extruder.

Adjust extruder or Pico position if needed.

Turn Fan On When You Begin Always turn the fan on

before warming up Pico. High fluctuations in fan airflow

during prints may cause jamming.

Hot Loading and Hot Unloading Filament When

loading filament, cut the end of the filament to an even

point or one-sided slant and insert when fan is on and

Pico is at its printing temperature.

To prevent clogs, you must swiftly unload filament when

fan is on and Pico is at least 75 percent of filament

printing temperature.

Purge Pico When Pico reaches printing temperature,

purge Pico by feeding in 30 -60mm of filament at an

intermediate speed (too fast may strip filament at the

extruder).

Print immediately after purging.

Avoid Letting Filament Sit Idle In Pico When at Printing Temperature

Pico User Guide