Cisco 2621 운영 - 페이지 17

{카테고리_이름} Cisco 2621에 대한 운영을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2621 25 페이지. Gateway-pbx interoperability: lucent/avaya definity g3si with e1 pri net5 signaling
Cisco 2621에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (20 페이지)

페이지 인쇄

•

Self-tests performed by the AIM-VPN/EP (cryptographic accelerator):

•

Secure Operation of the Cisco 2621XM/2651XM Router

The Cisco 2621XM and 2651XM Modular Access Routers with AIM-VPN/EP meet all the Level 2

requirements for FIPS 140-2. Follow the setting instructions provided below to place the module in FIPS

mode. Operating this router without maintaining the following settings will remove the module from

the FIPS approved mode of operation.

Initial Setup

•

Cisco 2621XM and Cisco 2651XM Modular Access Routers with AIM-VPN/EP FIPS 140-2 Non-Proprietary Security Policy

OL-6262-01

Conditional tests

Conditional bypass test

–

Pairwise consistency test on RSA signature

–

Continuous random number generator tests

–

Power-up tests

Firmware integrity test

–

DES KAT

–

TDES KAT

–

SHA-1 KAT

Conditional tests

–

Continuous random number generator test

The Crypto Officer must ensure that the AIM-VPN/EP cryptographic accelerator card is installed in

the module by opening the chassis and visually confirming the presence of the AIM-VPN/EP. Please

refer to the Cisco publication Installing Advanced Integration Modules in Cisco 2600 Series, Cisco

3600 Series, and Cisco 3700 Series Routers for detailed instructions on chassis disassembly and

reassembly, and AIM-VPN/EP identification. This document may be accessed on the web at:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/hw_inst/aim_inst/aims

_ins.pdf

The Crypto Officer must apply tamper evidence labels as described in the

section of this document.

Only a Crypto Officer may add and remove Network Modules. When removing the tamper evidence

label, the Crypto Officer should remove the entire label from the router and clean the cover of any

grease, dirt, or oil with an alcohol-based cleaning pad. The Crypto Officer must re-apply tamper

evidence labels on the router as described in the

Only a Crypto Officer may add and remove WAN Interface Cards. When removing the tamper

evidence label, the Crypto Officer should remove the entire label from the router and clean the cover

of any grease, dirt, or oil with an alcohol-based cleaning pad. The Crypto Officer must re-apply

tamper evidence labels on the router as described in the

document.

Secure Operation of the Cisco 2621XM/2651XM Router

"Physical Security"

section of this document.

"Physical Security"

section of this