Epson II 시작하기 - 페이지 12

{카테고리_이름} Epson II에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson II 27 페이지. Epson color scanner getting started

Connecting the Scanner to the Computer

Follow these steps to connect the scanner to your computer

and, for Windows 95, to configure the scanner port:

1. Turn off your computer, scanner, and any other peripheral

devices.

2. Connect the 25-pin end of the parallel cable to the parallel

port on your computer; then tighten the connector screws.

3. Connect the other end of the cable to the scanner's parallel

interface and fasten it with the wire clamps, as shown.

4. Turn on the scanner by pressing the OPERATE button. The

green OPERATE light

comes on. The READY light comes on when the scanner has

warmed up.

5. Turn on your monitor and all your other peripheral devices.

Then turn on the computer. (Always turn on the scanner

before the computer.)

Caution:

Be sure that your computer, scanner, and other peripheral

devices are turned off before you plug in the cable.

on the

top right side of the scanner