Cisco 3700 series 설치 및 포맷 - 페이지 10

{카테고리_이름} Cisco 3700 series에 대한 설치 및 포맷을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3700 series 34 페이지. Siemens hipath 4000 release 1 and siemens hicom 330e release 3.1 to cisco ios voice gateway using e1 qsig with h.323
Cisco 3700 series에 대해서도 마찬가지입니다: 업그레이드 지침 (30 페이지), 데이터시트 (8 페이지), 애플리케이션 노트 (41 페이지), 설치 매뉴얼 (12 페이지)

페이지 인쇄

Internal CompactFlash Memory Card Installation and Removal

Complete the following procedure to remove the chassis cover:

Power OFF the router. However, to channel ESD voltages to ground, do not unplug the power cable.

Step 1

Warning

Before opening the chassis, disconnect the telephone-network cables to avoid contact with

telephone-network voltages. To see translations of the various warnings that appear in this

publication, refer to the Regulatory Compliance and Safety Information document that

accompanied this device.

Step 2

Disconnect all network interface cables from the rear panel.

Step 3

Place the router on a flat surface. Remove the screws located on top of the cover (five screws on a

Cisco 2691 or Cisco 3631 router; six screws on a Cisco 3725 router). Set the screws aside in a safe

place.

Rotate the cover up to a 45-degree angle. (See

Step 4

Slide the cover to the side (away from the side with the fans) until the tabs are free from the slots. (See

Step 5

Figure

To replace the cover, see the

Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards

10,

Figure

11, or

Figure

12.)

"Reinstalling the Cover on a Cisco Router" section on page

Figure

10,

Figure

11, or

Figure

March 2002

12.)

16.

78-13892-03