Digitus DN-16085 빠른 설치 매뉴얼 - 페이지 2

{카테고리_이름} Digitus DN-16085에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitus DN-16085 2 페이지. Outdoor speed dome camera

페이지 인쇄
Digitus DN-16085 빠른 설치 매뉴얼
 Installation (Continued)
Step6: Slightly secure the camera and the bracket as indicated below.
screw
hole
Step7: Fasten the camera to the bracket with the M4 screw as indicated below.
 Cable Overview
RJ45 network cable
Alarm-in (Blue)
GND (Black)
RESET (Orange)
GND (Black)
Alarm-out (Purple)
Power cable
Color
Cable
--
Power cable
RJ45 network cable*
--
Black & Brown
GND
Yellow
Alarm-in
Pink
Alarm-out
Red
RESET
* For PoE (IEEE802.3af) installation, make sure your network cable has the maximum cable resistance of 20
Ω, such as CAT.5e or CAT.6 cables, to conform to the standard of IEEE802.3af.
Description
DC12V power supply.
Connect it to a RJ45 cable.
Ground wire
Reserved for external alarm device connection
Reserved for external alarm device connection
Remove the insulating coating of wire, and twist it with
a ground wire together to reset default camera
Step8: Replace the upper cover of the bracket back, and fasten it with a Philips screw or a hex socket
screw, and put the cap on it to finish the installation.
Upper cover
 Camera Configuration
Step1: Connect PC to the HUB connected to your camera(s)
with RJ45 network cable.
Step2: Install the "IPScan.exe" from the CD on your computer and
use this utility to find the IP address of the camera.
Step3: After searching, set your PC in the same network segment as the specific camera you want to
access, such as "192.168.30.xxx" (xxx could be 0~255) in our example
Step4: Note down the IP address and port number of the camera you want to access, such as
"192.168.30.1" and "88" in our example.
Step5: Open Internet Explorer on the PC, and enter the IP address and port number in the URL column to
access the camera. The format is http://ipaddress:portnum, such as http://192.168.30.1:88 in our
example.
Step6: Enter the default user name (admin) and password (admin) to access the camera. Then, go to
"Config" on the top right corner for more advanced configurations.
OR