Cisco 3800 Series 문제 해결 매뉴얼 - 페이지 2

{카테고리_이름} Cisco 3800 Series에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3800 Series 15 페이지. Password recovery procedure
Cisco 3800 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 애플리케이션 노트 (41 페이지), 데이터시트 (20 페이지), 빠른 시작 매뉴얼 (40 페이지), 구성 (32 페이지), 사용자 설명서 (7 페이지)

페이지 인쇄

1. Troubleshooting the Power and Cooling Systems

Solving Problems

The key to solving problems is to isolate the problem to a specific subsystem by comparing what the

router is doing to what it should be doing.

The LEDs on the front and rear panel of the router enable you to determine router performance and

operation. LEDs are described in the

When solving problems, consider the following subsystems:

•

Troubleshooting the Power and Cooling Systems

Both the system power LED and the fans can help you troubleshoot a power problem. Check the

following items.

The Cisco 3845 router has two system power LEDs, one for each power supply, labeled SYS PWR1 and

Note

SYS PWR2.

Normal Indications

With the power switch on, normal indications are:

•

Fault Indications

Check the following symptoms to locate or eliminate faults in the power and cooling systems:

•

Troubleshooting Cisco 3800 Series Routers

Power and cooling systems—External power source, power cable, router power supply and circuit

breaker, and router blower and fan. Also consider inadequate ventilation or air circulation.

Network modules and interface cards—LEDs on the modules and interface cards help identify a

failure.

Cables—External cables that connect the router to the network.

SYS LED steady green

SYS PWR LED steady green for the Cisco 3825 router, or SYS PWR1 or SYS PWR2 LED steady

green for the Cisco 3845 router (depending on which power supply is active)

Fans operating

With the power switch on, what color is the SYS LED?

If the LED is steady green, the router is receiving power and is functional.

–

If the LED is amber, the router is receiving power but is not functional.

–

If the LED is off, check the power source and power cable.

With the power switch on, the SYS LED steady green, and the SYS PWR LED (Cisco 3825) or

SYS PWR1 or SYS PWR2 LED (Cisco 3845) steady green, do the fans operate?

–

If yes, the power system is functioning.

–

If no, check the fans.

"LEDs" section on page

OL-5972-01