Cisco 3800 Series 빠른 시작 매뉴얼 - 페이지 26

{카테고리_이름} Cisco 3800 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3800 Series 40 페이지. Password recovery procedure
Cisco 3800 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 애플리케이션 노트 (41 페이지), 문제 해결 매뉴얼 (15 페이지), 데이터시트 (20 페이지), 구성 (32 페이지), 사용자 설명서 (7 페이지)

페이지 인쇄

System Management Connections

The connections described in Table 4 provide system management access.

The USB ports (version 1.1) are intended for future use only.

Note

Table 4

System Management Connections

Port

Console

Auxiliary

Power Up the Router

To ensure adequate cooling, never operate the router unless the cover and all modules and cover plates are installed.

Caution

Checklist for Power Up

You are ready to power up the Cisco 3800 series router after the following steps are completed:

• Chassis is securely mounted and grounded. (See the "Install Chassis" section on page 5.)

• Power and interface cables are connected. (See the "Connect Cables" section on page 16.)

• PC with HyperTerminal or similar terminal emulation program is connected to the console port, powered up, and

configured for 9600 baud, 8 data bits, 1 stop bit, no flow control, and no parity. (See the "Power Connections" section on

page 17.)

• Suitable PC COM port is selected in the terminal emulation program.

• You have selected passwords for access control.

• You have determined the IP addresses for the Ethernet and serial interfaces.

Note

For initial power-up, a direct console connection is recommended. After the initial configuration is completed, a remote

modem connection can be used for router management.

Power-Up Procedure

To power up your Cisco router and verify that it goes through its initialization and self-test, perform this procedure. When the

procedure is finished, the Cisco router is ready to configure.

To view the boot sequence, you must have a console connection to the Cisco router before it powers up.

Note

Make sure that your PC is powered up and connected as described in the "Checklist for Power Up" section on page 26.

Step 1

Move the power switch to the ON position on the router. The SYS LED blinks green on both the Cisco 3825 and Cisco

Step 2

3845 routers. During the boot process, the SYS PWR LED on the Cisco 3825 chassis is steady green, and the SYS PWR1

LED or SYS PWR2 LED on the Cisco 3845 chassis are off. If this does not happen, see the "Troubleshooting" document

Color

Connected To

Light blue PC or ASCII terminal communication port

(usually labeled COM)

Black

Modem for remote access

Cable

RJ-45-to-DB-9 console cable

RJ-45-to-DB-25 modem cable or

RJ-45-to-DB-9 console cable and DB-9

to DB-25 adapter