Cisco 3800 Series 구성 - 페이지 20
{카테고리_이름} Cisco 3800 Series에 대한 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3800 Series 32 페이지. Password recovery procedure
Cisco 3800 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 애플리케이션 노트 (41 페이지), 문제 해결 매뉴얼 (15 페이지), 데이터시트 (20 페이지), 빠른 시작 매뉴얼 (40 페이지), 사용자 설명서 (7 페이지)
페이지 인쇄
How to Configure Radio Settings on an Access Point
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface dot11Radio interface
Example:
Router(config)# interface dot11Radio 0/3/0
Step 4
payload-encapsulation {rfc1042 | dot1h}
Example:
Router(config-if)# no dot11 extension aironet
Step 5
end
Example:
Router(config-if)# end
Step 6
copy running-config startup-config
Example:
Router# copy running-config startup-config
20
enable
configure terminal
interface dot11Radio interface
payload-encapsulation {rfc1042 | dot1h}
end
copy running-config startup-config
Configuring Radio Settings on an Access Point
Purpose
Enables privileged EXEC mode.
•
Enter your password if prompted.
Enters global configuration mode.
Enters radio interface configuration mode.
•
The interface argument is in module/slot/port format,
except for the Cisco 800 series and Cisco 1800 series
fixed-configuration routers, where the interface
argument is either 0 or 1.
The 2.4-GHz radio is port 0, and the 5-GHz radio is
•
port 1.
Specifies the encapsulation transformation method to RFC
1042 (SNAP) or dot1h (IEEE 802.1h).
Returns to privileged EXEC mode.
(Optional) Saves your entries in the configuration file.