Cisco 3G MicroCell 사용자 설명서 - 페이지 9
{카테고리_이름} Cisco 3G MicroCell에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3G MicroCell 20 페이지. At&t wireless network gps signal extender
Cisco 3G MicroCell에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 빠른 시작 매뉴얼 (8 페이지), 사용자 설명서 (20 페이지)
페이지 인쇄
Option A
AT&T 3G MicroCell™
Note: Since you have a gateway or Wi-Fi router, you will NOT need to plug anything into the black port labeled 'Computer' on the 3G MicroCell.
Remove the sticker that covers the rear panel of your 3G MicroCell.
To ensure success, it is important to complete the steps below in order.
1. Take the
yellow Ethernet cable
'Ethernet'
on the 3G MicroCell.
2. Connect the other end of the
3. First,
turn off power
in the following order:
a) Gateway or Modem
b) Wi-Fi Router (if you have one)
c) 3G MicroCell
(Do this last
the 3G MicroCell and connect the other end to an
High Speed Internet with Gateway or Modem and Wi-Fi Router
Ethernet Cable
1
3
Power
Connect AC power adapter last.
that came with the 3G MicroCell and connect one end to the yellow port
yellow Ethernet cable
to your current internet equipment.
– connect one end of the
(Included)
2
to any open
Ethernet port on your gateway or Wi-Fi
Wait 1
minute, then
AC Power Adapter
AC
outlet.)
Gateway or Wi-Fi Router
Open Ports
turn on power
to your Internet equipment
to the port labeled
'Power'
Advance to page 12.
port labeled
router.
on
9